wet back design boiler

Boiler name: wet back design boiler
Boiler description: High efficiency, low back pressure, ultra-low NOx emissions
Location:: WUXI China
E-mail: [email protected]

Molten salt heaters use molten potassium nitrate and sodium nitrite as heating media. Molten salt heater will heat the powder salt over the melting point until the viscosity of the molten salt allows circulating pump works, after the whole system is under circulating condition, then feed then into the thermal fluid heater for further circulating rising temperature to make it to be recycling used. Normal media working temperature is 400-550℃, top working temperature could reach 600℃.

We're here to help:

Easy ways to get the answers you need.

Leave Your Reply

Scotch Marine Boiler | Three Pass Wetback | Series 4

Built in accordance with the ASME Code, the wet back design has proven to give much longer useful life cycles than dry back boilers. Quality Each unit is tested and inspected and registered with the National Board of Boiler and Pressure Vessel Inspectors.

What is a wetback? When should you use it in building desi

Wetbacks generally provide a boost to the water heating system, particularly in the winter when most required. They are most suitable for cold climates where a lot of space heating is used.

US3211134A - Wet back boiler - Google Paten

In one form, the wet back boiler includes a fire tube which passes through the chamber containing the liquid to be heated, e.g. water, and the fire tube terminates short of the chamber end but is braced at its terminating end against the chamber end.

Pages - Shell Boile

A further development of the economic boiler was the creation of a three-pass wet back boiler which is a standard configuration in use today, (see Figure 3.2.4). This design has evolved as materials and manufacturing technology has advanced: thinner metal tubes were introduced allowing more tubes to be accommodated, the heat transfer rates to

What is a wetback? When should you use it in building desi

Wetbacks generally provide a boost to the water heating system, particularly in the winter when most required. They are most suitable for cold climates where a lot of space heating is used.

Powermaster » Wet-Ba

The weakest part of a conventional fire tube boiler is found in the combustion gas turnaround chamber, located just after the boiler furnace and comprised of the refractory frame and the back lid, the latter of which is made of refractory and insulating materials.

PowerPoint Presentati

Scotch Marine Boiler Design Goal The purpose of this presentation is to provide project decision-makers with fundamental, and critical, boiler design information.

Powermaster » Wet-Ba

The weakest part of a conventional fire tube boiler is found in the combustion gas turnaround chamber, located just after the boiler furnace and comprised of the refractory frame and the back lid, the latter of which is made of refractory and insulating materials.

542C-3D-30 - Prime Boiler Servic

York Shipley Horizontal Firetube Boiler Available in two-pass, three-pass or four-pass design Available in dry-back or wet-back versions Suitable for all commercial and industrial applications Highly reliable, robust design Available in two-pass, three-pass or four-pass design Available in dry-back or wet-back versions Suitable for all commercial and industrial applications Highly reliable

Why Our Boilers Are Designed As Wet-Back Boilers: Dry-Bac

Why Our Boilers Are Designed As Wet-Back Boilers: Dry-Back Boiler VS Wet-Back Boiler 2016-05-13 Reversal chamber is the posterior portion of the boiler combustion chamber through which the flue gases travel from the furnace’s first pass to the second pass tubes.

Wetback vs Dryback firetube boiler desi

The wet back boiler design uses separate tube sheets between tube passes which can be more forgiving with load changes. Wetback firetube boilers offer a more optimal functional footprint, with lift off or split-hinged doors that require no cool-down period and can be opened immediately.